Humminbird 1155C - Manual (Page 10)

The GPS Receiver included with your 1100 Series™ Chartplotter allows you to combine easy-to-use
chartplotter and navigation capabilities. The following GPS functionality is currently supported by the 1100
Series™ Chartplotter when it is connected to the included GPS receiver:
• View current position
• View current track (breadcrumb trail)
• View precision speed and heading from your GPS receiver
• Save tracks, waypoints and routes
• Travel a route and navigate from one waypoint to the next.
Your 1100 Series™ supports Navionics® Gold, HotMaps™, HotMaps™ Premium, and Platinum™
Cartography on MMC or SD card media.
NOTE: Your 1100 Series™ does not support Navionics® Classic Charts, only Navionics® Gold, HotMaps™,
HotMaps™ Premium, and Platinum™ Cartography.
NOTE: Some models come pre-loaded with Navionics® cartography and are referred to as NVB models. NVB
models are only available domestically. Currently, there are not any international NVB models.
In non-NVB models, your unit also comes with a built-in UniMap™ with a detailed map of North America
(Domestic models) or a detailed map of Europe and Southeast Asia, including Australia and New Zealand
(International models). In non-NVB models, the built-in UniMap™ does not contain Port, Tide or Current
information, and this information is only available from optional purchase MMC/SD cards.
Your 1100 Series™ uses the GPS Receiver to determine the position of the boat automatically, and uses
the zoom level settings on a particular view to select the best chart to display. See Viewing Cartography
for more information.
MMC/SD Slot
Your 1100 Series™ Chartplotter also has an MMC/SD slot that is
used to insert optional-purchase cards containing additional
detailed maps. If you insert an MMC/SD that contains a more
detailed chart for a particular location, your 1100 Series™
Chartplotter will retrieve that chart and display it automatically.
Use the illustration to locate the position of the MMC/SD slot
cover, open the MMC/SD slot cover, then insert the MMC/SD
into the slot. The label on the MMC/SD should face toward the
left side of the unit. Press down on the card until it clicks into
place and close the slot cover.
Inserting an MMC/SD into the Card Slot
2