Humminbird 1155C - Manual (Page 20)

5. Insert the control head through the mounting hole from the front side of the dash. Place a
washer, lock washer, and wing nut onto each threaded rod and tighten fully.
6. Thread the cables through the opening in the back of the cable collector cover.
7. Insert cable connectors into the proper recesses on the cable collector insert. The cable
connectors are keyed to prevent reverse installation, so be careful not to force the connectors into
the wrong slots. If you don’t have a cable for every hole in the insert, install the blank plugs to
protect the control head from the weather.
8. Line up the cable collector insert and cover, with the keying feature, then slide the cover into
place on the insert.
Cable Collector Insert 1
Screws 2
Cable Collector Cover 3
Assembling the Cable Collector
3
1
2
Not Used
Cable Collector Cover
4
5
Cable Collector Insert 6
Inserting the Cables into the Cable Connector Insert
1 2
3 4 Power
Communications
1
2
Temp/Speed 3
5
6
12