Humminbird 1155C - Manual (Page 24)

2. Screw on the receiver base to the stem first, making sure that the stem pipe does not protrude
from the receiver base. This adds protection to the cable when pulling it through the pipe stem.
In addition to this, de-burr the pipe edges to reduce cable abrasion.
3. Use electrical tape to secure the NMEA cable to the receiver cable as shown.
NOTE: Leave the NMEA cable secured to the receiver cable unless needed. This will make removing the receiver
easier.
4. Route the GPS receiver cable through the stem and continue with the planned route you chose
in step 1.
5. Attach the GPS receiver to its base using the included #6 - 7/8" screws.
NMEA Cable Taped
NMEA Cable Out
Mounting Screws
1
2
3
1
2
3
Receiver
Receiver Base
1
2
Stem Pipe 3
1
3
2
16