HONDA 08E92-SNA-100B - Manual (Page 13)

© 2008 American Honda Motor Co., Inc. - All Rights Reserved. AII 38216-38957 (0802)
13 of 21
46. Secure the engine starter harness to the vehicle
harness using a wire tie.
• With driver's dashboard under cover: Secure
in the hole you made in the instrument panel.
• Without driver's dashboard under cover:
Secure through the existing hole for under
cover securing.
47. Use the clip on the engine starter harness to
secure the engine starter harness to the fuse box.
45. With driver's dashboard under cover: Measure
the indicated dimension on the instrument panel
and mark with a felt-tip pen and a center punch.
Drill a 3 mm hole and then a 7 mm hole at the
marked position of the instrument panel.
– Wear safety goggles during drilling.
– Using a file, remove the burrs at the edges
of the holes you made.
6D01351T
INSTRUMENT
PANEL
CENTER
PUNCH
FELT-TIP PEN
View from below
12 mm
(0.5 in.)
6 mm
(0.2 in.)
FRONT
6D01361T
INSTRUMENT PANEL
DRILL
DRILL BIT
(3 mm, 7 mm)
6D01172T
CLIP FUSE
BOX
WIRE TIE
WITH DRIVER’S
DASHBOARD UNDER
COVER
www.collegehillshonda.com