HP QMS 4060 - Manual (Page 55)

Operator Control
Menu
4-21 Printer Configuration
» Note: Collating through your application is more time consuming
than collating through the printer. The application sends the
complete job the requested number of times rather than sending
it once and holding data in printer memory.
Orientation
While you can usually specify the orientation of a print job in your
application, if you consistently use a certain paper orientation, you
can set this in the Operator Control/Orientation menu.
Input
Your QMS 4060 Print System comes standard with three 500-sheet
paper trays. Using the control panel, you can select a default paper
input source, chain these input sources, and name them.
Selecting a Paper Inputbin
Your printer has the following inputbins:
Menu Operator Control/Orientation
Choices Portrait—Vertical.
Landscape—Horizontal.
Default Portrait
Upper Tray Holds approximately 500 sheets of letter/A4 to
A3/11" x 17" paper.
Middle Tray Holds approximately 500 sheets of letter/A4 to
A3/11" x 17" paper.
Lower Tray Holds approximately 500 sheets of letter/A4 to
A3/11" x 17" paper.