Harman Stove Company The Harman Accentra Pellet Insert - Manual (Page 8)

9
Top and Lid Assembly
Center
Medallion
Flame Guide
Heat
Exchanger
Cover
Ash Pan
(2) Spring Latches
(One on each side)
Fig. 11
Installation: Removing unit from skid
How to Reduce the Weight for Installation
1. Remove the top/lid assembly and side panels.
•
Note: Removal of the cast hopper lid itself is
NOT necessary or recommended.
•
Note: The hopper lid must be in the "OPEN" position
befo re the top/lid a ssembly can be lifted of f or
reinstalled on the stove body.
•
There are (4) 1/4-20 x 1/2" flange head bolts securing
the top/lid assembly to the stove body. They can be
removed from the underside with a 3/8" socket.
The cast top and lid assembly bolt down bars:
On each side of the stove body, underneath the cast
top, are (2) 1/4" flange head bolts.See Fig. 12.
These bolts pull the cast top and lid assembly down
onto the hopper gasket to seal the hopper.
They also allow for a small amount of front to back
adjustment for alignment of the top into the wing
pockets.
Internal
Cast Iron
(4) pieces
Mounting Shell
Protector Angles: These angles are designed to
protect the blower motor from damage when
placed on a flat surface. Be careful where and
how the stove body is handled.
Be careful not to
damage
the
distribution blower
located under the
insert. There are
gua rds on bot h
sides of the motor
to allow the insert
to re st on a flat
surface, however,
extra care should
be taken.
Distribution Blower
Bolts require a
3/8" socket.
(View looking up under the cast top.)
Top bolt down bar
Fig. 10
Fig. 12
Remove the cast side panels by lifting them upward
off of the hinge pins. See Fig. 13.
Evaluation notes were added to the output document. To get rid of these notes, please order your copy of ePrint IV now.