Hayes Microcomputer Products PC Card - Manual (Page 35)

DIVA T/A PC Card Reference Guide 35
COM Port Configuration Commands—Continued
Command Description
AT&Kn Flow Control (AT&Kn): This command
allows you to enable and disable flow control
so that data is stopped and restarted when
buffer space becomes available.
n=0
Disables flow control
n=3
Enables RTS/CTS flow control (default)
n=4
Enables XON/XOFF flow control
n=6
Enables both RTS/CTS and XON/XOFF flow
control
AT&Sn Data Set Ready: Data Set Ready (DSR)
controls the behavior of the DSR output.
n=0
DSR always on (default).
n=1
DSR always on after protocol is connected.
ATEn Local Echo: The E command enables or
disables command echo on your computer. If
you do not see commands entered on your
screen, enable command echo. If you see
double characters, disable command echo.
n=0
Disables local echo.
n=1
Enables local echo (default).
AT%MT1=n Set Turbo Mode Bit Rate: Specifies the turbo
bitrate value.
n=a value from 128,000 to 512000
n=0 disables turbo.
Default=512000