Hayes Microcomputer Products PC Card - Manual (Page 36)

DIVA T/A PC Card Reference Guide 36
COM Port Configuration Commands—Continued
Command Description
AT%MT2=n Set Turbo Mode Threshold: Specifies the
minimum PC bitrate threshold for the
activation of turbo mode.
n=a value in the range 57,600 to 115,200
Default=115200
ATQn Quiet Result Codes: This command enables or
disables the sending of result codes to the DTE.
n=0
Enables result codes to the DTE (default).
n=1
Disables result codes to the DTE.
ATS2=n Escape Character: Use this command to
configure the character used to escape from the
data mode and return to the AT command
mode.
n can be a value between 0-255 (default is
ASCII 043, translates into the “+” character).
A value of 128-255 disables the escape
function.
ATS3=n Carriage Return Character: Sets the
character that the AT command processor uses
to detect the end of a command line in both the
receive and transmit directions.
n can be a value between 0-127(default is
ASCII 013 which translates into the carriage
return character).
ATS4=n Line Feed Character: Sets the character that
the AT command processor uses to indicate the
end of each status message.
n can be a value between 0-127 (default is
ASCII 010 line feed).