HP 9100 series - Manual (Page 255)

ENWW Control-panel messages 253
SCANNER LOCKED. PRESS ? FOR HELP. Scanner is locked. Unlock the scanner from
underneath the print-carriage access door. See
Printing supplies area for information about finding
the scanner lock. Refer to the Getting Started Guide
for more information about unlocking the scanner.
Once the scanner has been unlocked, press
(select button) to continue.
SCANNER NOT RESPONDING. PRESS ? FOR
HELP. The all-in-one scanner is not responding. Make
sure that the scanner has been unlocked. See
Printing supplies area for information about finding
the scanner lock. Refer to the Getting Started Guide
for more information about unlocking the scanner. If
the problem the persists, turn off the power to the
all-in-one, wait 5 seconds, and then turn on the
power. If the problem continues, the scanner
module may have failed.
SERVICE STALL. PRESS TO
CONTINUE.
An all-in-one motor has stalled. Press (select
button) for the all-in-one to attempt automatic
recovery and clear the message. If the message
persists, contact an HP-authorized service or
support provider.
SHARENAME IS INCORRECT. PRESS TO
CONTINUE
The sharename is incorrect. Use the control panel
or the EWS to correct the sharename.
SMTP SERVER NOT CONFIGURED. PRESS
TO CONTINUE
The SMTP server is not configured. Go to the EMAIL
SETUP menu or use the EWS to configure the SMTP
server.
TRAY 2 DOES NOT SUPPORT CUSTOM MEDIA
SIZE. LOAD TRAY 1, PRESS
TO
CONTINUE
Custom media size is supported in tray 1 only.
Load tray 1 with custom media and press
(select button) to continue.
WAIT FOR PAGE TO DRY OR PRESS TO
CONTINUE.
The all-in-one is waiting for the printed page to dry
before continuing to print. You can remove the page
from the output tray (handle it carefully to avoid
smearing the ink), and press
(select button) to
start printing the next page.
Message Description