HP 9100 series - Manual (Page 116)

114 9 - Managing the administrator functions ENWW
z HP Web Jetadmin software
Open the HP Web Jetadmin software. See the software documentation for information
about alerts and notifications.
Resetting the HP Jetdirect print server
Resetting the HP Jetdirect print server restores the factory default values of the HP Jetdirect
print server.
Note When you restore the factory default values for the HP Jetdirect print server, all previously
stored EIO settings are lost.
To reset the HP Jetdirect print server
1 Press (P OWER ) to turn off the all-in-one.
2 While holding down the (down), -, and B LACK /C OLOR buttons on the control panel,
press (P OWER ) to turn on the all-in-one.
Upgrading the firmware in the all-in-one
From time to time, Hewlett-Packard provides firmware upgrades for products. These upgrades
provide additional or improved functionality. When a firmware upgrade for the all-in-one is
available, a notification message appears on the HP Instant Support homepage. You can
open the download site from the homepage. You can also obtain information about available
upgrades at
http://www.hp.com/support/officejet9100 .
Use the methods in the following sections to upgrade the firmware. See the readme file
associated with the firmware upgrade for details.
You do not need to keep a firmware upgrade file after you have performed the upgrade.
CAUTION Do not cancel the firmware upgrade after you have started it. Canceling the process can
damage the firmware in the all-in-one.
To upgrade the firmware by using the firmware download utility (FDU)
1 Download the firmware upgrade file from the HP website and store it on the hard disk of
your computer.
2 Browse to the location of the firmware upgrade file and open the file.