Hampton Direct HI300 - Manual (Page 12)

Hampton HI300 Wood Cast Insert 12
INSTALLATION
4) Slowly slide the Mantel Top forward until it stops.
Slide
Mantel Top
5) Mount the Top Faceplate by carefully sliding the Mounting Plates
on the Left and Right Side Faceplate thru the Retainers in the
Top Faceplate.
NOTE: Slowly lower the Top Faceplate into position; being careful
not to damage the Mantel Top.
Backside of Unit & Faceplate Shown.
Retainer
Mounting Plates
Top Face-
plate
Cast
adjustment
bolts
Cast
mounting
bolts
for height
adustment.
Right Side
Faceplate
Left Side
Faceplate
6) Carefully slide the Mantel Top back into position.
See Step 3 to identify side casts.
See next page for recommended measurements.
Slide
Mantel Top
6 ) If unable to align side faceplate to unit and top
faceplate further adjustments need to be made, complete
one side at a time. Loosen all bolts on brackets (6 per side).
Loosen top and bottom bolts (Shown below).
Adjust left or right side cast plates to allow further adjustment
on faceplate. Once aligned, hold side surround in place and
tighten all bolts. If side cast height needs adjusting, loosen 2
bolts holding cast bracket and adjust up or down
.