Hampton Direct HI300 - Manual (Page 14)

Hampton HI300 Wood Cast Insert 14
1. Ensure the unit is out from the fi replace opening by at least 4” before
assembling the faceplate.
2. Remove the 4 bolts and washers on each side of the unit (shown
below).
3. Secure the side faceplate mounting plates to the left and right side of
the unit using 4 bolts and washers (removed in step 2) per bracket
as shown in diagram 1. Leave bolts loose to allow for adjustment.
Stop! Read Carefully.
Enamel & Cast components are very fragile. Use extreme care when handling.
4. Attach the 2 nut retainers to the top of the fi rebox as shown in
diagram 2. May need to be tapped lightly into place with a
hammer.
Diagram 1
Diagram 2
Nut Retainers
5. Place the mantel top on the fi rebox ensuring that the screw holes in
the mantel top line up with the nut retainers. See diagram 3.
Diagram 3
6. Take the 2 capscrews provided and place a washer (1/4 x 3/4) and
pushnut over each capscrew, as shown in diagram 4.
Diagram 4
FACEPLATE CONTENTS LIST
Qty Description
1 Mantel Top
1 Top Oversize Surround
1 Right Side Oversize Surround
1 Left Side Oversize Surround
2 Top Corner Faceplate Mounting Plate
2 Side Faceplate Mounting Plate
10 Bolts - 1/4-20 x 1/2 Hex Head
10 Washers - 1/4 split lock
12 Washers - 1/4 fl at x 3/4
2 Pushnut
2 Capscrew
2 Nut Retainer
2 Insulation
1 3 ft. Gasket
1 Logo
Right
Side Cast
Mantel Top
OVERSIZE CAST FACEPLATE INSTALLATION
INSTALLATION