Hampton Direct HI300 - Manual (Page 24)

Hampton HI300 Wood Cast Insert 24
DOOR GASKET
If the door gasket requires replacement, 7/8"
diameter material must be used. A proper high
temperature gasket adhesive is required. A
gasket repair kit, Part # 846-570 is available
from your local Hampton dealer.
GLASS CLEANING
Only clean your glass window when it is cool.
Your local retailer can supply you with special
glass cleaner if plain water and a soft cloth
does not remove all deposits.
MAINTENANCE
Remove 8 screws.
GLASS
REPLACEMENT
1) Remove door from unit.
2) To replace the glass remove the 8 screws
highlighted in the diagram below.
3) Lift off the glass retainer and carefully remove
glass.
4) Place new glass in the door, make sure that
the glass gasketing will properly seal your
unit.
5) Position the glass retainer back on. Ensure
that it rests on the gasket and not the glass.
6) Secure glass retainer using the 8 screws. Do
not wrench down on the glass as this may
cause the glass to break.
7) Place door back on unit.
HANDLE
REPLACEMENT
1) Remove handle by undoing the hex head
bolt using a 7/16" socket wrench.
2) Fit new door handle over latch and se-
cure.
Assemble handle by:
a) Placing lock washer over hex head
bolt.
b) Place hex head bolt into handle.
c) Place spacer over hex head bolt
threads.
d) Screw handle into door latch.
Hex Head
Bolt
Lock
Washer
Handle
Spacer
DOOR REMOVAL
When handling enamel parts, please handle
with care as they can be damaged.
1) Remove the Top Faceplate by lifting
straight up from the sides.
2) Lift off Mantel Top.
3) Open the Door and lift up off its hinges.
Please be careful when removing the
Door and not to drop onto the Ashlip,
it may chip.
Avoid impact on glass doors such
as striking or slamming shut.
Door
Hinges
DOOR INSTALLATION NOTE
After re-installing the door, carefully
swing open and check the clearance
to the Right Hand Cast Side. If tight or
rubbing, loosen the 7/16 nuts and adjust
the clearance and then re-tighten.