Hampton Direct HI300 - Manual (Page 19)

Hampton HI300 Wood Cast Insert 19
INSTALLATION
1) Remove the Phillips screw, located on the top of the
fan housing, which attaches the fan defl ector to the
main fan body.
2) Take off the 2 screws from the fan switch plate as-
sembly, and remove it from the left casting face.
3) Take off the 2 bolts, nuts, and washers from the
thermodisc assembly, and remove it from the main
fan body. Retain the screws for reattachment on the
other side.
4) Remove the green ground wire from the left side of
the fan motor, by detaching the phillips screw. Keep
the screw to reattach the green ground wire on the
other side.
5) Raising the fan defl ector, pull the wire harness, switch
plate, ground wire and thermodisc assembly from
the left side and relocate to the right side of the main
fan housing. See step 10 for Thermodisc Assembly
installation.
Important Note:
The wire harness may be tight between the fan motor
and main body but will move over and down to the
base with a little fl exing of the fan motor. Ensure the
wire harness rests on the base when pulled over.
6) Remove the 2x 7/16" bolts from the right casting.
Discard the existing casting plate and attach the
new casting plate with the switch plate assembly.
7) Remove the top black screw from the leg on theight
side of the fan motor, and attach the screw to the
leg on the left side.
bolts
Fan Housing
Fan Switch
Plate Assembly
Thermodisc
Assembly
Right Side Le
Existing Casting Plate
8) Attach the green ground wire with the #8 x 3/8" Pan
Head Phillips steel self tapping screw, previously
removed from the left side.
POWER OUTLET CONVERSION