Home Dynamix DW 3512 - Manual (Page 26)

Dynamix DW 3512 Technical Manual V1.00
Copyright © 2007 Dynamix Pro., Ltd. All right reserved. 26
Identifier). You may use the default SSID unless there more than one DW3512 in the same
area. In this case, you should specify different SSID for each DW3512.
¾ Channel Number: Set channel for wireless connection. You can set channel for radio
communication manually. If you set it as Auto, the DW3512 will select a clear channel during
boot up.
¾ Associated Clients: Press Show Active Clients to see which client registers on this DW3512.
¾ Enable Universal Repeater Mode (Acting as AP and client simultaneously): Enable this
feature will perform DW3512 to work as Universal Repeater.
¾ SSID of Extended Interface: User could input SSID of Extended Interface here if Universal
Repeater is enabled.
For more information regarding WDS, AP+WDS and Universal Repeater mode, please refer
to CH 4 Wireless Operation Modes.
„ Advanced Setting
These settings are only for more technically advanced users who have a sufficient knowledge
about wireless LAN. These settings should not be changed unless you know what effect the
changes will have on your Access Point.
¾ Authentication Type: Select authentication type as Open System, Shared Key, or Auto. With
Open System authentication, a wireless PC can join any network and receive any messages
that are not encrypted. With Shared Key authentication, only those PCs that possess the
correct authentication key can join the network.
¾ Fragment Threshold (256-2346): set fragment threshold size. Fragments are small pieces