Home Dynamix DW 3512 - Manual (Page 32)

Dynamix DW 3512 Technical Manual V1.00
Copyright © 2007 Dynamix Pro., Ltd. All right reserved. 32
¾ Default Gateway: Set default gateway of LAN interface. It is normally used when Bridge mode
is enabled.
¾ DHCP: Set DHCP mode to be disabled, Client, or Server. When user set DHCP mode as
server mode, please set DHCP Client Range for LAN interface to assign DHCP IP.
¾ Show Client: Press this key can check current DHCP clients that captured IP from DW3512.
Press Refresh can renew screen display, and press Close can close window.
¾ DHCP Client Range: Set DHCP IP range for DW3512 to assign IP address for other device in
LAN.
¾ 802.1d Spanning: Enable or disable 802.1d Spanning Tree function.
„ WAN Interface
This page is used to configure the parameters for Internet network which connects to the WAN port
of your Access Point. Here you may change the access method to static IP, DHCP or PPPoE by
click the item value of WAN Access type.
¾ WAN Access Type: Select WAN mode as Static IP/ DHCP Client/ PPPoE.
1) Static IP: Set WAN interface as Static IP mode.
2) IP Address: Set IP address of WAN interface.
3) Subnet Mask: Set subnet mask of WAN interface.
4) Default Gateway: Set default gateway of WAN interface.
5) MTU Size: Set MTU (maximum transmission unit) size.
6) DNS 1/DNS 2/ DNS 3: Set three alternative Domain Name Server for WAN interface.
7) Enable UPnP: check to enable UPnP function.
8) Enable Ping Access on WAN: If this function is checked to enable, user can reach
DW3512 via Ping WAN IP address.