Harman Stove Company Advance Pellet Stove - Manual (Page 20)

20
Opening and Closing the View Door
Opening:
The view door must be opened for cleaning of
the glass and scraping of the burn pot. This should be
done with the unit off and cool, in most cases. Although
the glass can be cleaned and burn pot scraped while
the unit is at low burn.
1. Using scraper as shown in Fig. 34and 35, lift the
door latch forward and up.
2. Swing the door open to the left, stopping the swing
when resistance is felt. Forcing the door open further
then was designed may cause damage to the door or
it's hinges.
CAUTION
Do not put excessive downward pressure on the
latch end of the door while in the open position.
If the door is going to be opened for an extended period
of time, it is suggested that it be removed (see Fig. 36)
and set safely aside.
3. Inspect the door gasket and glass gaskets for worn
or missing pieces. Replace if necessary. (Fig. 37)
Closing:
When closing the door, always hold the door
latch all the way up until it has caught the receiving
bolt. Then push the latch downward and back until the
door is fully seated. See Fig. 35.
Removing View Door:
To remove the view door from the stove, hold
the door by the bottom and lift upward off of the hinge
pins.See Fig. 36.
Inspect the door gasket.See Fig. 37.
REPLACE GLASS WITH
CERAMIC GLASS ONLY.
Fig. 34
Fig. 35
Fig. 36
Fig. 37
Receiving Bolt
WARNING
Door latch may
be hot!
Maintenance - Cleaning Glass on View Door
Evaluation notes were added to the output document. To get rid of these notes, please order your copy of ePrint IV now.