Harman Stove Company Advance Pellet Stove - Manual (Page 9)

9
Fig. 9
Fig.10
Fig.11 Fig.12
Fig.13
Side Door
Magnets
Removing Side Doors
Figure 9
Use hand hole to swing open side doors to at least
90
o .
Figure 10
Remove side doors by lifting upward on the door until
the bottom pin is out of its hole. Move the bottom of
the door out and away from the pedestal base about
1/2". Allow the door to slide downward until the top
door pin is out of its top hole.
NOTE: Always remove the side doors and rear
shields to move the unit. This will keep them from
getting damaged.
Removing the Rear Motor Shield Sheet Metal.
NOTE: Disconnect power to the unit before
removing the motor shields. Danger of electrical
shock. Hot and moving parts could cause injury.
Figure 11
There are (2) #10 hex head screws holding each rear
shield. Using a 5/16" nut driver or socket, loosen the
(2) screws about 4 or 5 turns.
Figure 12
Slide the rear shields straight outward until the ends
come out of the rear retaining clips, as seen in Fig.13.
Placing Rear Shields Back on Unit
1. When replacing the shields, always insert the top
and bottom ends of the sheet metal into the retaining
clips first.
2. Slide the shields straight inward until the (2) hex
head screws are fully inserted into the stove slots.
3. Make sure the top edges of the shield are against
the hopper bottom and tighten screws.
Rear Shields are split around the Flue Tail pipe and
outside Air Hole Knockout. This will allow removal and
installation of the rear shields with the unit completely
installed.
Rear Shield Retaining clip
Outside Air
Flex Hole
Knockout
Skid Hold Down
Screws
Side
Door
S
id
e
D
o
o
r
Rear
Shield
Rear
Shield
Rear
Shield
Removing Side Doors for Installation
Evaluation notes were added to the output document. To get rid of these notes, please order your copy of ePrint IV now.