Hand Held Products 7900 Series - Manual (Page 33)

Dolphin® 7900 Series Mobile Computer User’s Guide 3 - 7
4. Using the special tool from Hand Held Products, unscrew both screws.
Installing a Mini-SD Card
1. When the access door is open, slide the mini-SD card into the appropriate slot until it clicks into place.
2. The bottom, inside panel of the opening displays the following guide to help you insert the mini-SD card correctly:
To remove an installed mini-SD card, tap on the edge lightly to unlock the card; the card will pop out just enough for you to
grab its edge and pull it out.
3. Put the access door back in place and tighten the screws.
There is a rubber gasket on the inside of access door that must be in place when you seal the door. This gasket performs the
sealing action for the door.
When closed, the access door seals the memory interface from moisture and particle intrusion thus preserving the
terminal’s environmental rating. The access door must be properly sealed before resuming terminal operation. Failure to
seal the access door will void the warranty.
Rubber Gasket
SIM mSD
!