Hitachi Koki USA 52 - Manual (Page 61)

3-23
5. Selecting the Finishing
Chapt
e
r 3
M
a
king
Copi
es
Touch the desired finishing function key.
Touch
.
NOTES
• The size of the copy paper for Hole Punch is
11
″
×17
″
L, LegalL, LetterL and LetterC only.
• Hole Punch is not possible in the Interrupt
mode.
• When making copies in the Hole Punch Mode,
make sure to load the originals into the
Document Handler in the correct direction.
☞p. 3-31
<Only when the Finisher FN-3 is mounted>
• The number of punch holes can be changed
between “2-Hole” and “3-Hole” by using the
Knob located inside the Finisher.
* When changing the setting for the number of
holes to be made, be sure the marks are
aligned.
Pull out Knob: 2-Hole
Push in Knob: 3-Hole
* The number of punch holes can be graphically
identified on the Display.
Useful Tips
• If you do not select a hole-punching position,
the copier autmatically sets the Hole Punch
position according to the original feeding
direction ilustrated below.
• When making copies from either the 11
″×
17
″
or LegalL size, the copier autmatically speify
the hole punching position as shown below.
Hole Punch
1
Hole Punch
1155P014CB
Knob
1155O723AA
1155O789EA
Original Copy
Original Copy
1155O790EA
Original Copy
1155O791EA