Hand Held Products 7450 - Manual (Page 25)

2 - 9
DetectoidCE
After running DetectoidPC, start Detectoid CE on the Dolphin terminal selecting Start>Programs>HHP>DetectoidCE.
DetectoidCE will attempt to find the connection with the PC. If successful, the discovered settings will be saved and the
Communications Properties Launch window shown below will then display on your Dolphin. The default is Start ActiveSync when
the unit is docked or connected. By choosing the default, ActiveSync will start automatically when the terminal is connected via
a powered serial cable or docked in a powered HomeBase/IntelliBase. If you select Do not automatically start ActiveSync, you
must manually start ActiveSync on the Dolphin terminal to establish communications (see Chapter 6).
If you want to go back and change the settings later, select Start>Settings>Control Panel>Communication Properties and
select the Launch tab.
Once the communications parameters have been detected and configured, the status indicator will change to Success. Verify
that the ActiveSync settings are correct, then click save to transfer those settings to ActiveSync.