Hand Held Products 7450 - Manual (Page 98)

12 - 6
USB HomeBase
There is a 5V DC power supply connector and a USB connector:
Power supply connector Use this connector to attach a power supply to the USB HomeBase. The power supply provides 5V
DC input for communications and battery charging.
USB Communications Port Use a USB full-speed detachable cable to connect this downstream device port to an upstream
USB Host or Hub. The USB HomeBase is USB 1.3 compliant.
Bottom Panel of IntelliBase
A Baud Rate switch used to select the communication baud rate is located on the bottom of the IntelliBase. The Baud Rate Switch
on the IntelliBase is a four-position switch. Switch position and the corresponding baud rates are shown in the charts below.
The USB HomeBase does not require a baud rate switch.
Power Supply
Connector
USB Connector
Baud Rate
Switch