Hand Held Products 7450 - Manual (Page 104)

12 - 12
In the ActiveSync connection settings, add check mark to "Allow serial cable or infrared connection to this COM port" and select
"Infrared Port (IR)" for the COM port as shown below. Do not check "Allow USB connection with this desktop computer". It has
no effect for the USB HomeBase.
To configure the Dolphin 7400/7450 terminal for communications, see the previous section on Configuring the Dolphin
Terminal.
Communicating with the Dolphin Terminal
To communicate with the Dolphin and any other devices connected to the Dolphin Charging/Communication cradle:
1. Insert the Dolphin into the terminal well of the IntelliBase/USB HomeBase. If the Dolphin is in sleep mode, it will awaken into
active state.
2. The DOCK LED on the cradle will illuminate. If the Dolphin does not turn on, or the LED does not light up, make sure that it
is properly seated in the terminal well and that the power supply is properly connected to the cradle and plugged into a
functioning AC outlet.
3. Start your application on the Dolphin terminal or the host computer. Data can then begin transmitting between the terminal
and the devices connected to the Dolphin cradle.
When data transfer begins, the COMM LED on the cradle will blink red and green. If the IntelliBase/HomeBase will not
communicate with the Dolphin, check the port connections to ensure that the cradle is correctly configured.