hussmann GSVM - Manual (Page 11)

11
LIGHTING –
Interior lighting is provided by a
cool white fluorescent bulb under the top
header (standard), and additional lights
under each shelf. The tubes are sleeved to
maintain proper heat around the bulb for
maximum light intensity and to protect the
product in case of breakage.
The tubes can be replaced without
removing shelves or product. To replace
the bulb, twist th e bulb and slide the
prongs clear of the lampholder. When re-
installing this type of bulb, be sure the
prongs on the bulb twist and lock into
place.
LIGHT SWITCH (es) -
The standard cas e has one upper
light with a switch located under the top
left end behind the honeycomb. Addition-
ally, the lighting on each shelf has a sep a-
rate switch located under the center of
each shelf.
BALLAST (s) -
The ballast for the top standard
light is located in the e lectrical box. Access
is gained by removing the access panel.
Access to the shelving ballasts is gained by
removing the respective shelf (after u n-
plu g ging the harness), and removing the
three screws from the ballast cover.
CLEANING EXTERIOR –
When cleaning the exterior of the
cabinet, use a soft cloth or sponges with
water and a mild detergent. Rinse and
wipe dry. Do not use an abrasive cleanser
on the painted surfaces as this will mar the
finish.
For plexiglass windows, use an a p-
proved plexiglass cleaner such as Craftics
20/20 Plasti -Cleaner.
CLEANING INTERIOR –
For cleaning the interior of the
product compartment, remove the product,
disconnect the electrical power, and allow
cabinet to warm to room temperature. Use
a soft cloth or sponge with a mild detergent
to wash the interior.
The drainage area and drain should
be checked to insure that they have not be-
come clogged. If the condensate drain hose
is removed from the electric condensate
pan for cleaning, it must be reinstalled
prior to operating the case. Do not use an
abrasive cleanser on the painted surfaces
GSVM-4060 only has Electric Condensate Pan as Standard
Wipe dry before restarting the cabi-
net. The time clock (see Defrost Time
Clock section) should be reset to the correct
time of day. Allow the cabinet to cool down
to proper temperature before reloading
product.