hussmann GSVM - Manual (Page 4)

4
INTRODUCTION –
The Hussmann Model GSVM open
vertical merchandiser offers versatility in
the display of medium temperature (35-
41ºF) products such as diary products,
prepared salads, pizza and fresh entrees
that are pre-chilled in a cooler.
So that you can realize maximum
benefit from this fine piece of equipment
we urge both you and your installer to
carefully read and follow this brief set of
instructions prior to installation of the
equipment.
INSPECTION –
The equipment has been skidded
and crated prior to shipment from the
factory. It is the carrier’s responsibility to
deliver it to you in good condition until
such time as you sign for it.
Upon receipt of the cabinet,
examine the packaging for damage. If the
packaging is damaged, make specific
notation on the delivery ticket as to the
location and extent of damage prior to
signing for the piece.
Carefully remove packaging and
examine the cabinet for damage. If
damage is found, contact the delivering
carrier immediately and request that his
agent prepare an inspection report for the
purpose of filing a claim. THIS IS YOUR
RESPONSIBILITY, NOT THE
FACTORY’S.
Save all packaging materials and
move the cabinet as little as possible prior
to inspection.
LOCATION and CLEARANCE –
It is important that careful
consideration be given to locating the
cabinet away from an area where direct
sunlight would shine into the fixture, or
where drafts from air conditioning grilles,
fans, and open doors could affect its
operation.
The GSVM4060 and 4072 have
front condenser air intake and discharge.
A minimum distance of two feet must be
left open in front of the case so that air
discharge and intake to the condensing
unit is not obstructed.
The GSVM5272 model requires a
5" minimum clearance behind the case
and clear above the case since it has
straight through condenser air flow.
Brackets are provided for field
attachment to obtain the 5" spacing.
SKID –
The skid should be left on the
cabinet until it is near its final location.
The skid provides protection for both case
and floor.
The skid is removed by raising one
end of the case approx. 6", block securely
and remove the 2 skid bolts on the raised
end – then screw back into the holes 2 leg
levelers.