hussmann GSVM - Manual (Page 16)

16
Ballast Hums 1. Check voltage
2. Replace ballast
GSVM ACCESSORIES
The following is a description of the various accessories available for the GSVM,
including sketches, where applicable of the many shelving/wire goods items available.
CASTER KIT – Consists of 5" braking casters, which screw in to the standard threaded
holes in the four corners under the case occupied by the standard leg levelers, which will
have to be removed. The kit will add 5 5/8" to the height of the case.
LEG KIT – The legs also go into the same holes as the standard levelers, which will have to
be removed. The legs are adjustable and will add 5 5/16 to the height of the case. The skirt
kit requires the use of these legs.
4-SIDED SKIRT KIT – As stated, this is a 4-sided skirt that will enclose the open area
under the case when the leg kit is used. It clamps onto the legs.
NIGHT COVER – This is a clear, 5 mil. thick, polyester shade type of cover that will cover
the face of the case. It will fasten to the top of the case and be drawn to a snap fastener in
the area above the front bumper. The cover, although loose fitting on the ends, will
conserve energy during periods when the store is not open. The cover is standard on the
GSVM5272 effective August ’96.
WRAP-AROUND BUMPER KIT – This bumper replaces the standard front bumper and
warps around both sides of the case at the standard height of 22" to the centerline of the 2
1/4" wide bumper.
COLORED ACCENT PANEL – This panel can be (a) the top front panel over the product
or (b) the panel behind the bumper or (c) the access panel below the bumper panel, or any
combination of these.
SHELF END TRIM KIT – Consists of (4) painted steel ends for the standard 13" and 15"
shelves. This trim conceals and protects the exposed ends of the shelves, and attaches by
two snap fasteners supplied with each trim piece for the 4060. The 4072 and 5272 need 6.
HIGH HUMIDITY CONDENSATE PAN – (For GSVM4072 & 5272) This is a 1,000 watt,9
amp pan with a 6ft-9 in 115v power cord attached. Dedicated circuit required.