Changing the redial settings, To change the redial-on-busy option, To change the redial-on-no-answer option – HP 2830 User Manual
Page 107: To change the redial-on-communication-error option, Changing the, Redial settings
Changing the redial settings
If the device was unable to send a fax because the receiving fax machine did not answer or
was busy, the device attempts to redial based on the redial-on-busy, redial-on-no-answer,
and redial-on-communication-error options. Use the procedures in this section to turn these
options on or off.
To change the redial-on-busy option
If this option is turned on, the device redials automatically if it receives a busy signal. The
factory-set default for the redial-on-busy option is On.
1. On the device control panel, press
M
ENU
.
2. Use the
<
or the
>
button to select Fax setup, and then press
E
NTER
.
3. Use the
<
or the
>
button to select Fax Send setup, and then press
E
NTER
.
4. Use the
<
or the
>
button to select Redial if busy, and then press
E
NTER
.
5. Use the
<
or the
>
button to select On or Off, and then press
E
NTER
.
To change the redial-on-no-answer option
If this option is turned on, the device redials automatically if the receiving machine does not
answer. The factory-set default for the redial-on-no-answer option is Off.
1. On the device control panel, press
M
ENU
.
2. Use the
<
or the
>
button to select Fax setup, and then press
E
NTER
.
3. Use the
<
or the
>
button to select Fax Send setup, and then press
E
NTER
.
4. Use the
<
or the
>
button to select Redial-no answer, and then press
E
NTER
.
5. Use the
<
or the
>
button to select On or Off, and then press
E
NTER
.
To change the redial-on-communication-error option
If this option is turned on, the device redials automatically if some sort of communication
error occurs. The factory-set default for the redial-on-communication-error option is On.
1. On the device control panel, press
M
ENU
.
2. Use the
<
or the
>
button to select Fax setup, and then press
E
NTER
.
3. Use the
<
or the
>
button to select Fax Send setup, and then press
E
NTER
.
4. Use the
<
or the
>
button to select Redial Comm Err., and then press
E
NTER
.
5. Use the
<
or the
>
button to select On or Off, and then press
E
NTER
.
ENWW
Changing the redial settings
91