HP 2830 - Manual (Page 125)

Using fax forwarding
You can set your device to forward incoming faxes to another fax number. When the fax
arrives at your device, it is stored in the memory. The device then dials the fax number that
you have specified and sends the fax. If the device cannot forward a fax because of an error
(for example, the number is busy) and repeated redial attempts are unsuccessful, your
device prints the fax.
If the device runs out of memory while receiving a fax, it terminates the incoming fax and
only forwards the pages and partial pages that have been stored in the memory.
When it is using the fax-forwarding feature, the device (rather than the computer) must be
receiving the faxes, and the answer mode must be set to Automatic (see
Setting the answer
mode ).
To use fax forwarding
1. On the device control panel, press M
ENU
.
2. Use the < or the > button to select Fax setup, and then press E
NTER
.
3. Use the < or the > button to select Fax Recv. setup, and then press E
NTER
.
4. Use the < or the > button to select Forward fax, and then press E
NTER
.
5. Press the > button to select On or Off, and then press E
NTER
.
6. If you turn on the fax-forwarding feature, use the alphanumeric buttons to specify the fax
number where the fax is to be sent, and then press E
NTER
to save your selection.
ENWW Using fax forwarding 109