HP 445946-001 User Manual

Page 45

Advertising
background image

Ports and trunking

45

In the configuration shown in the table above, Actor switch ports 18 and 19 aggregate to form an LACP

trunk group with Partner switch ports 1 and 2. At the same time, Actor switch ports 20 and 21 form a

different LACP trunk group with a different partner.
LACP automatically determines which member links can be aggregated and then aggregates them. It
provides for the controlled addition and removal of physical links for the link aggregation.
Each port in the HP 10GbE switch can have one of the following LACP modes.

off (default)—The user can configure this port in to a regular static trunk group.

active—The port is capable of forming an LACP trunk. This port sends LACPDU packets to partner

system ports.

passive—The port is capable of forming an LACP trunk. This port only responds to the LACPDU

packets sent from an LACP active port.

Each active LACP port transmits LACP data units (LACPDUs), while each passive LACP port listens for

LACPDUs. During LACP negotiation, the admin key is exchanged. The LACP trunk group is enabled as

long as the information matches at both ends of the link. If the admin key value changes for a port at

either end of the link, that port’s association with the LACP trunk group is lost.
When the system is initialized, all ports by default are in LACP

off

mode and are assigned unique admin

keys. To make a group of ports aggregatable, you assign them all the same admin key. You must set the

port’s LACP mode to active to activate LACP negotiation. You can set other port’s LACP mode to passive,

to reduce the amount of LACPDU traffic at the initial trunk-forming stage.
Use the

/info/l2/trunk

command or the

/info/l2/lacp/dump

command to check whether the

ports are trunked.

NOTE:

If you configure LACP on ports with 802.1x network access control, make sure the ports on

both sides of the connection are properly configured for both LACP and 802.1x.

Advertising