HP 445946-001 - Manual (Page 52)

Port-based Network Access and traffic control
52
Configuring port-based traffic control
To configure a port for traffic control, perform the following steps:
1. Configure the traffic-control threshold and enable traffic control.
Main# /cfg/port 2
>> Port 2# brate 150000 (Set broadcast threshold)
>> Port 2# mrate 150000 (Set multicast threshold)
>> Port 2# drate 150000 (Set DLF threshold)
2. To disable a traffic-control threshold, use the following command:
>> Port 2# mrate dis (Disable multicast threshold)
3. Apply and save the configuration.
>> Port 2# apply (Apply the port configurations)
>> Port 2# save (Save the port configurations)