Hand Held Products 2020/5620 - Manual (Page 121)

IMAGETEAM™ 2020/5620 System Manual 8 - 1
8
Utilities
To Add a Test Code I.D. Prefix to All Symbologies
This selection allows you to turn on transmission of a Code I.D. before the
decoded symbology. (See the Symbology Chart, included in the
Appendix
A , page A-1) for the single character code that identifies each symbology.) This
action first clears all current prefixes, then programs a Code I.D. prefix for all
symbologies. This is a temporary setting that will be removed when the unit is
reset. For instructions on how to reset your scanner, refer to
Reset Scanner
(page 8-1).
Reset Scanner
Scanning the following bar code clears temporary settings in the scanner and
returns scanner to normal operation. Scanning this bar code also causes the
scanner to re-link the radio.
Show Software Revision
Scan the bar code below to output the current software revision, unit serial
number, and other product information for both the scanner and base.
Show Data Format
Scan the bar code below to show current data format settings.
Add Code I.D. Prefix to
All Symbologies (Temporary)
Reset Scanner
Show Revision
Data Format Settings