Hand Held Products 2020/5620 - Manual (Page 24)

1 - 8 IMAGETEAM™ 2020/5620 System Manual
Out-of-Range Alarm
Duration
If your scanner is out range of the base, an alarm sounds from both your base
and scanner. To activate the alarm options for the scanner or the base and to
set the alarm duration, scan the appropriate bar code below and then set the
time-out duration (from 0-3000 seconds) by scanning digits on the
Programming
Chart inside the back cover, then scanning Save. Default = 0 sec (no alarm).
Note: If you are out of range when you scan a bar code, you will receive an error
beep even if you do not have the alarm set. You receive the error beep
since the data could not be communicated to the base or the host.
Alarm Sound Type
If you have set the out-of-range alarm enabled, you may change the alarm type
for the scanner or base by scanning the appropriate bar code below and then
scanning a digit (0-7) bar code and the Save bar code on the
Programming Chart
inside the back cover of this manual. Default = 0. Set the sound type to fit your
application.
Base Duration Alarm
Scanner Duration Alarm
Base Alarm Type
Scanner Alarm Type