Hamilton Electronics MICROLAB 8534-01 - Manual (Page 12)

MICROLAB
®
Carousel User Guide (June 2003)
10
Connecting cables
To install the carousel power and communication cables:
1. Connect the USB cable (4427-02) to the USB port of the carousel
housing assembly (refer to figure 7).
2. Connect the other end of the USB cable to one of the USB ports of
the computer that will be used to operate the carousel.
3. Plug the power cord into the power outlet in the side of the housing
assembly. Orient the plug as shown in figure 9. Plug the power
adapter into a wall outlet.
Figure 9: Plug orientation
The carousel can be controlled via RS-232 instead of USB. If Vector software will be used to control
the carousel, then USB is preferred.