Harman Stove Company 828i User Manual
Page 13
13
confirm that there is no blockage and that the
system is in good repair. Directions for conducting
a flue spillage test may be found on page 6. The
vent manufacturer's instructions may provide
specific suggestions or details on vent inspection.
Any sections that are taken apart for the inspection
must be reassembled and sealed as required.
CLEANING THE GLASS
The glass may be cleaned with ordinary house-
hold glass cleaner and a soft cloth or paper towel.
WARNING: Never clean the glass when it is
hot. Do not use abrasive cleaners on the glass.
CLEANING THE LOG SET AND FIREBOX
During the annual inspection and maintenance
appointment, the service person should clean dust,
lint, and any light accumulation from the logs and
the firebox area. An extra-soft brush should be
used on the logs as they are extremely fragile; a
vacuum cleaner may be used on the firebox. If at
any time the logs cannot be removed or installed
without forcing, the cause must be found. The logs
must never be forced. Follow this sequence:
1. Remove the side trim panels according to the
directions on page 12.
2. Remove the glass door according to the direc-
tions on page 12.
3. Remove, clean, and re-install the log set, observ-
ing the directions on log handling and placement
found on pages 7 and 8.
CONVECTION BLOWER SERVICE ACCESS
The blower is located behind a panel that can be
accessed by first removing the fuel module. See
page 15 for instructions. Remove the two fasteners
securing the panel and pull the panel forward. The
blower will come out with the panel. Disconnect
the blower electrical connector to completely
remove the blower from the unit.
CAUTION: If the door is opened or re-
moved for servicing, it must be replaced and
securely closed before operating the appli-
ance. The glass must be securely fixed in the
door when operating the appliance.