Preparation, Included in this package, Material and tools required – Honeywell NIAGARA WEB-700 User Manual

Page 6: Precautions, Safety precautions, Preparation 6, Included in this package 6, Material and tools required 6, Precautions 6, Safety precautions 6

Advertising
background image

WEB-700 WEB-700-O CP-700

95-7776—03

6

PREPARATION

Unpack the WEB/CP-700 and inspect the package contents for damaged or missing components. If damaged, notify the

appropriate carrier at once and return any damaged components for immediate repair or replacement. See “Returning a

Defective Unit” on page 25.

Included in this Package

Material and Tools Required

Included in this Package

Included in this package you should find the following items:

• WEB/CP-700 controller.

WEB/CP-700 Installation Instructions, Form Number 95-7776.

• Hardware bag containing the following items:

— Two (2) 6-position screw terminal plugs, one for integral contact inputs (door tamper, UPS battery OK, UPS AC present),

one end-mount to wire RS-485/power to optional remote expansion devices.

— One (1) 2-position screw terminal plug for external sealed lead-acid (SLA) rechargeable battery (not provided).

— One (1) grounding wire, with quick-disconnect 0.187" female connector.

Material and Tools Required

The following supplies and tools are typically required for installation:

• NPB-PWR-UN-H universal AC power supply module, 90-263 Vac input, 15Vdc 30W output, DIN-mount capable, with

grounding wire.

Alternatively, a NPB-WPM-US wall-mount AC adapter can power the WEB/CP-700 controller only. You must cut off the

adapter’s barrel plug end, and then wire leads into the controller’s end connector. A multimeter is needed to check polarity.

• DIN rail, type NS35/7.5 (35mm x 7.5mm) and DIN rail end-clips (stop clips), unless using panel mounting method with screws

through mounting tabs.

• Suitable tools and fasteners for mounting unit and accessories.

• #2 phillips screwdriver: used to install and remove an optional option card.

• Small flat-blade screwdriver: used for making wiring connections to removable screw terminal plugs.

• (Optional) One or two 12V sealed-lead-acid (SLA) rechargeable backup batteries, with wire harness for connecting to the

2-position connector on the unit. Should be sized as required by the system. See Contact Input wiring to WEB/CP-700, page

17.

PRECAUTIONS

This document uses the following warning and caution conventions:

CAUTION

Cautions remind the reader to be careful. They alert readers to situations where there is a chance that the reader

might perform an action that cannot be undone, might receive unexpected results, or might lose data. Cautions

contain an explanation of why the action is potentially problematic.

WARNING

Warnings alert the reader to proceed with extreme care in situations where there is a chance that the reader

might do something that can result in personal injury or equipment damage. Warnings contain an explanation of

why the action is potentially dangerous.

Safety Precautions

The following items are warnings of a general nature relating to the installation and start-up of the WEB/CP-700 controller. Be

sure to heed these warnings to prevent personal injury or equipment damage.

Advertising
This manual is related to the following products: