HONDA FL5540K1 User Manual
Page 22
FRONT LOADER ASSEMBLY
PRESSURE and SUCTION HYDRAULIC HOSE
CONNECTION
4.
Remove the pipe plug from
body
and clean the threads and then install the
pressure hose. Remove the plastic caps
from the pump outlets. Use sealer on
threads and screw the other end (swivel
connector end) into the threaded pipe
fitting on the pump. Slide the suction hose
(large hose) over the pipe end at the
bottom of
and pipe end on
the pump. Attach with hose clamps and
tighten securely.
5.
Attach the front guard on the front of the
sub-frame using two each
inch and
inch bolts, and four each
inch nuts and washers.
Do not tighten
bolts at this time.
ATTACHING LOADING MASTS
6.
Move the tractor until the masts are
positioned over the upright pads on the
sub-frame, use two people to lower the
masts onto the pads and insert the fixing
pins through the masts and pads. Install
clip pins to retain fixing pins.
Masts may have to be shaken to align fixing
pin holes.
ESSURE
HOSE
HOSE
CLAM
PUMP
SUCTION
HOSE
CLIP PIN
FIXING PIN
20