Hornet Car Security 700T - Manual (Page 11)

© 2001 Directed Electronics, Inc. Vista, CA 11
3. Insert the twisted pair of wires into one end of the butt connector and crimp securely.
4. Insert the other end of the vehicle’s wire into the other end of the butt connector and crimp securely.
1. Using your wire strippers and razor knife, strip about 1 /
2
-inch of insulation off the wire to be connected to,
without cutting the wire.
2. Twist the security module’s wire around the bare section of the vehicle’s wire.
3. Solder the bare connection thoroughly using rosin core solder.
4. Completely insulate the connection with electrical tape.
Module Wire
Vehicle Wire
Solder
Soldering Iron
Module Wire
Vehicle Wire
Stripped Vehicle Wire
solder connections
Crimp
Module Wire
Vehicle Wire
Vehicle Wire
Crimp