Hornet Car Security 700T User Manual
Page 13
© 2001 Directed Electronics, Inc. Vista, CA
13
As shipped, this wire should be connected to the (+) parking light wire. If the light flash polarity jumper inside
the unit is moved to the opposite position (see the Internal Jumpers section of this guide), this wire supplies a
(-) 200 mA output. This is suitable for driving (-) parking light wires.
This input is used to bypass sensor inputs when the trunk is opened using the factory transmitter. Connect this
wire to the (+) trunk release output of the factory keyless entry system or trunk release relay. When the system
receives a (+) input on this wire, zones 2 and 4 are bypassed for three seconds. If during that three seconds,
ground is applied to the H1/6 BLUE wire zones 2 and 4 will remain bypassed until the ground input is removed.
This means that when the trunk is opened with the factory transmitter the only triggers that remains active while
the trunk is open are the doors. Three seconds after the trunk is closed the bypassed zones will become active
again.
H1/3 WHITE/BLUE (+) trunk release/sensor shunt input
H1/2 WHITE light flash output