Hornet Car Security 700T - Manual (Page 22)

22 © 2001 Directed Electronics, Inc. Vista, CA
internal programming jumper
This jumper is used to determine the light flash output. In the (+) position, the on-board relay is enabled and
the unit will output (+)12V on the WHITE wire, H1/2. In the (-) position, the on-board relay is disabled. The
WHITE wire, H1/2, will supply a (-) 200 mA output suitable for driving factory parking light relays. To access the
jumper, remove the sliding door from on top of the control module.
light flash jumper