D. finishing material, St-36tr-ipi, Pier-36tr-ipi – Heat & Glo Fireplace ST-36TRLP-IPI User Manual
Page 61
61
Heat & Glo • ST-36TR-IPI, PIER-36TR-IPI • 2176-900 Rev. G • 3/13
Figure 13.19 Overlap Fit Door
Figure 13.18 Folio Door and Aero
Figure 13.20 Inside Fit Door
DOOR
FIT
FINISH MATERIAL
MAXIMUM
THICKNESS
SEE FIGURE
Aero
Inside
Any
13.18
Folio
Inside
Any
13.18
Arcadia
Overlap
1 inch
13.19
Inside
Any
13.20
Halston
Overlap
1 inch
13.19
Inside
1 inch - 2 inch
13.21
Chateau
Overlap
1 inch
13.19
Inside
Any
13.20
Valencia
Overlap
1 inch
13.19
Inside
Any
13.20
Galleria
Overlap
1 inch
13.19
Inside
1 inch - 2 inch
13.21
Figure 13.21 Operable Hinge Door
D. Finishing Material
Only doors certifi ed for use with this appliance model may
be used. Contact your dealer for a list of doors that may
be used. Once you have determined what kind of door
and fi nishing material is going to be used on the fi replace,
you may use the table below which shows the door mod-
els and the fi nishing material thickness allowed. For an
inside fi t there is an available template to assist with siz-
ing the fi nishing material.
Stop fi nishing material fl ush with opening.
DOOR
FINISHING
MATERIAL
FINISHING
MATERIAL
(Outside door width)
(Includes 1/8 in. opening each side of door)
37 in.
37-1/4 in.
Finishing materials over 1 inch thick.
Finishing material between 1 and 2 inches thick.
FINISHING MATERIAL
DOOR
FINISHING MATERIAL
1 in. MAX
FINISHING MATERIAL
(TOP EDGE)
DOOR
FRONT FACE OF FIREPLACE
37 in.
33-3/4 in.
(Inside door height)
37-1/4 in.
34 in.
(Outside door width)
(Includes 1/8 in. opening each side of door)
FINISHING
MATERIAL
FINISHING
MATERIAL
*IF FINISHING MATERIAL IS THICKER THAN
2 IN., DOORS WILL ONLY OPEN
AS FAR AS PICTURED
DOORS
37-1/4 IN.
33-3/4 IN.
34 IN.
Finishing materials 1 inch maximum thick.
Stop fi nishing material fl ush with opening.
ST-36TR-IPI
DOOR
FIT
FINISH MATERIAL
MAXIMUM
THICKNESS
SEE FIGURE
Aero
Inside
Any
13.22
Chateau
Inside
Any
13.22
Arcadia
Inside
Any
13.22
PIER-36TR-IPI