Heat & Glo Fireplace ST-36TRLP-IPI - Manual (Page 66)

Heat & Glo • ST-36TR-IPI, PIER-36TR-IPI • 2176-900 Rev. G • 3/13 66
F. Install the Log Assembly
2005-937F 9/08
Log Set Assembly: LOGS-MSR
Models: PIER-HV, ST-HV, LCOR-HV, RCOR-HV
ST-36TR, PIER-36TR, TWILIGHT-II-B
CAUTION: Logs are fragile! Carefully remove the logs
from the packaging. Remove the cardboard support from
inside of fi replace.
STEP 2. LOG #1 (SRV2005-701): Use the indent on the bottom side of the log to position the large end of the log onto
the grate bar as shown. Slide the log back until the indent engages the grate tine as shown above. Position the thin end of
log #1 one inch from port pattern as shown.
STEP 3. LOG #2 (SRV2005-700): Position log #2 on the left grate bar and the pilot assembly. Use the cut out notches
on the log to position it as shown.
STEP 1. Before positioning the logs, refer to the instal-
lation manual for electric ember set-up and ember place-
ment.
1 1
2 2
PILOT PILOT
ASSEMBLY ASSEMBLY
CUTOUT CUTOUT
GRATE BAR CUTOUT GRATE BAR CUTOUT
1-inch 1-inch
1 1
1 1
2 2
4 4
5 5 6 6
3 3
PIER-HV, ST-HV, RCOR-HV, ST-36TR, PIER-36TR, TWILIGHT-II-B
(See page 4 for LCOR-HV)
PILOT ASSEMBLY PILOT ASSEMBLY
INDENT INDENT
BACK VIEW BACK VIEW
BOTTOM VIEW BOTTOM VIEW
GRATE TINE (HIDDEN) GRATE TINE (HIDDEN)
GRATE GRATE
BAR
BAR
INDENT INDENT