Harley-Davidson CLASSIC CHROME H4808 - Manual (Page 13)

13
Assembly
TM
Right Exhaust
Pipe - Outer Half
• Fit the outer half of the right exhaust pipe (R) to the
inner half of the right exhaust pipe.
Hint: Use a long-shaft Phillips screwdriver to complete
this assembly step.
• Align the holes in the inner half of the right exhaust pipe
with the holes in the vehicle frame.
• Insert four #8 x 3 /
4
" screws through the inner half of the
right exhaust pipe and into the vehicle frame.
IMPORTANT! The screw marked with an asterisk * in the
illustration above must go through the hole in the inner
half of the right exhaust pipe, the vehicle body and into
the vehicle frame. Make sure all the holes are properly
aligned and the screw goes through all three parts.
• Tighten the screws.
TM
Vehicle
Frame
Right Exhaust
Pipe - Inner Half
*
8
9
TM
Right Exhaust
Pipe
• With the holes of both halves aligned, insert six #8 x 3 /
4
"
screws to join the two halves of the right exhaust pipe.
• Tighten the screws.
• Repeat steps 7 through 10 to assemble both left
exhaust pipe (L) pieces to the left side of the vehicle.
10
Right
Strut
Right Rear
Fender
• Fit the right strut onto the right rear fender of the
vehicle body.
• Insert two #8 x 3 /
4
" screws into the top of the right strut
and hand-tighten only. You will fully tighten these screws
in the next step.
11
Right Side View