Harley-Davidson CLASSIC CHROME H4808 - Manual (Page 22)

22
Assembly
TM
• Insert a #8 x 3 /
4
" screw through the hole in each side of
the tank and tighten.
Hint: To replace the batteries in the sound box, simply
remove the screws from the tank and remove the tank
from the vehicle frame. After replacing the batteries, be
sure to replace the sound box, tank and screws.
Tank
Vehicle
Frame
TM
• Balance the sound box on the vehicle body. (The speaker
should face down.)
• Fit the tabs at the bottom of the tank under the front end
of the vehicle body.
• Lower the tank on the vehicle frame, making sure that the
two small square openings in the tank fit over the buttons
on the sound box.
Sound Box
Buttons
Tabs
Tank
43
44
• Loosen the screw in the sound box battery compartment
door and open the battery compartment.
• Insert three “AA” (LR6) alkaline batteries in the
sound box.
Hint: For longest battery life, use only alkaline batteries.
• Close the battery compartment door and tighten
the screw.
Sound Box
Battery
Compartment
Battery
Compartment
Door
SHOWN ACTUAL SIZE
1.5V x 3
“AA” (LR6)
Battery Safety Information
Batteries may leak fluids that can cause chemical burn
injury or ruin your product. To avoid battery leakage:
• Do not mix old and new batteries or batteries of
different types: alkaline, standard (carbon-zinc) or
rechargeable (nickel-cadmium).
• Insert batteries as indicated inside the battery
compartment.
• Remove batteries during long periods of non-use.
Always remove exhausted batteries from the product.
Dispose of batteries safely. Do not dispose of batteries
in a fire. The batteries may explode or leak.
• Never short-circuit the battery terminals.
• Non-rechargeable batteries are not to be recharged.
• Use only batteries of the same or equivalent type as
recommended.
• Do not charge non-rechargeable batteries.
• Remove rechargeable batteries from the product before
charging.
• If removable rechargeable batteries are used, they are
only to be charged under adult supervision
42
Right Side View