HONDA Outboard Motor BF5A - Manual (Page 25)

23
SAFE OPERATING
PRECAUTIONS BREAK-IN PROCEDURE
TRANSOM ANGLE
ADJUSTMENT
OPERATION
TRANSOM ANGLE
ADJUSTING ROD
TO CHANGE
TO LOCK
UNLOCKED
POSITION
LOCKED POSITION
IMPORTANT SAFETY
INFORMATION
BEFORE OPERATION.
To safely realize the full potential of
this outboard motor, you need a
complete understanding of its
operation and a certain amount of
practice with its controls.
Before operating the outboard motor
for the first time, please review the
on page and the
chapter titled
For your safety, avoid starting or
operating the engine in an enclosed
area. Your engine’s exhaust contains
poisonous carbon monoxide gas
which can collect rapidly in an
enclosed area and cause illness or
death.
Proper break-in procedure allows the
moving parts to wear in smoothly for
best performance and long service
life.
For the first 10 hours, run the
outboard motor at low speed, and
avoid full-throttle operation.
The transom angle adjusting rod is
used to adjust the angle of the
outboard motor in the normal
operating position (p.
).
To adjust, first tilt the outboard
motor so it is not resting on the rod.
Push the rod in and turn the end of
the rod up, so the latch will fall
into line with the rod.
Remove the rod and reinsert it in
the desired position.
Push the rod in and turn the end of
the rod down, so the latch will fall
to the locked position. Then
release the rod.
6
33
1.
2.
3.
4.
07/01/08 13:06:27 31ZV1630_024