HONDA Outboard Motor BF5A - Manual (Page 72)

70
TAKING CARE OF UNEXPECTED PROBLEMS
When cranking the engine with
an open ignition circuit (spark
plug removed f rom the ignition
circuit), remove the clip f rom
the engine stop switch to
prevent possible damage to the
ignition system.
Attempt to start the engine.
Reinstall the spark plug, and put
the emergency stop switch clip
into the switch.
If the engine fails to start, remove
the spark plug, clean and dry it,
then reinstall the spark plug and
attempt to start the engine again.
Pour a teaspoon of engine oil into
the spark plug hole, then pull the
starter grip several times to
lubricate the inside of the cylinder.
If the engine starts, and no
mechanical damage is evident,
continue to run the engine for a
half hour or longer. Be sure the
water level is at least two inches
above the antiventilation plate to
avoid overheating and water pump
damage.
As soon as possible, take the
outboard motor to an authorized
Honda marine dealer for
inspection and service.
5.
6.
7.
8.
07/01/08 13:16:28 31ZV1630_071