HP 2200 - Manual (Page 14)

load originals and load paper 8
hp psc 2200 series
2 Close the lid.
load paper
Following is the basic procedure for loading paper. There are specific
considerations for loading certain types of paper, transparency film,
postcards, and envelopes. After you review this procedure, see tips for
loading other types of paper in the paper tray on page 11, load 4 x 6 inch
photo paper on page 10, load envelopes on page 9, and load postcards
or hagaki cards on page 11.
For best results, adjust the paper settings each time you change paper types
or paper sizes. For more information, see set the paper type on page 12.
to load the paper tray
1 Remove the output tray, and slide the paper-width and paper-length
guides to their outermost positions.
2 Tap the stack on a flat surface to align the edges of the paper, and
then check the paper for the following:
–
Make sure it is free of rips, dust, wrinkles, and curled or bent
edges.
– Make sure all the paper in the stack is the same size and type,
unless you are working with photo paper.
3 Insert paper into the paper tray print-side down until it stops. If you are
using letterhead, insert the top of the page first.
Be careful not to use too much or too little paper. Check that the stack
of paper contains several sheets but is no higher than the top of the
paper-length guide.
Diagrams stamped on the output tray provide tips
for installing print cartridges. The location of the
Support Web site for OfficeJet products is also
provided.