HP 2200 - Manual (Page 48)

use the fax features 42
hp psc 2200 series
redial a busy or unanswered number automatically
You can set your HP PSC to redial a busy or an unanswered number
automatically. The default setting for Busy Redial is Redial. The default
setting for No Answer Redial is No Redial.
1 Press Setup.
2 Do one of the following:
–
Press 4, then press 3.
This selects Advanced Fax Setup, then selects Busy Redial.
– Press 4, then press 4 again.
This selects Advanced Fax Setup, then selects No Answer Redial.
3 Press to select Redial or No Redial, as desired.
4 Press Enter.
use error correction mode (ECM)
ECM eliminates data lost due to poor phone lines by detecting errors that
occur during transmission and automatically requesting retransmission of
the erroneous portion. Phone charges are unaffected, or may even be
reduced, on good phone lines. On poor phone lines, ECM increases
sending time and phone charges, but sends the data much more reliably.
Turn ECM off (the default setting is on) only if it increases phone charges
substantially and you are willing to accept poorer quality in exchange for
reduced charges.
1 Press Setup.
2 Press 4, then press 7.
This selects Advanced Fax Setup, then selects Error Correction Mode.
3 Press to switch between Off and On.
4 Press Enter to use the selected setting.
set automatic reduction
This setting determines what your HP PSC does if it receives a fax too large
for the default paper size. With this setting on (the default), the image is
reduced so that it attempts to fit on one page. With this feature off, the
information that will not fit on the first page is printed on a second page.
1 Press Setup.
2 Press 4, then press 5.
This selects Advanced Fax Setup, then selects Automatic Reduction.
3 Press to switch between Off and On.
4 Press Enter to use the selected setting.