Hitachi HANDYTONE-486 - Manual (Page 14)

HandyTone-486 User Manual Grandstream Networks, Inc.
14
5.2.6 3-way Conferencing
HandyTone-496 supports 3-way conference in two styles: star code style or Bellcore style.
5.2.6.1 Star Code Style 3-way Conference
Assuming that call party A and B are in conversation. A wants to bring C in a conference:
1. A presses FLASH (on the analog phone, or Hook Flash for old model phones) to get a dial
tone.
2. A dials *23 then C’s number then # (or wait for 4 seconds).
3. If C answers the call, then A press “flash” to bring B, C in the conference.
4. If C does not answer the call, A can press “flash” back to talk to B.
5.2.6.2 Bellcore Style 3-way Conference
Bellcore style 3-way conference is also supported. To do this, user needs to enable “Use Bell-style 3-
way Conference” in FXS1 or FXS2 web configuration.
Assuming that call party A and B are in conversation. A wants to bring C in a conference:
1. A presses FLASH (on the analog phone, or Hook Flash for old model phones) to get a dial
tone.
2. A dials C’s number then # (or wait for 4 seconds).
3. If C answers the call, then A press “flash” to bring B, C in the conference.
4. If C does not answer the call, A can press “flash” back to talk to B.
5.2.7 PSTN Pass Through/Life line
HandyTone-486 Rev. 2.0 supports PSTN pass through. User can send and receive PSTN calls with the
attached analog phone.
To receive PSTN calls, simply make phone off hook when the analog phone rings.
To make a PSTN call, press the PSTN access code (*00 by default, or any number configured in web
configuration page) to switch to PSTN line and get a dial tone, then dial the PSTN number.
When HandyTone-486 is out of power, it will function as a jack. User can use the same analog phone
for PSTN calls.
5.3 Call Features
5.3.1 Call Features Table (star code)
Following table shows the call features (* code) of HandyTone-486.
VoIPon www.voipon.co.uk [email protected] Tel: +44 (0)1245 808195 Fax: +44 (0)1245 600030