Hitachi HANDYTONE-486 - Manual (Page 17)

HandyTone-486 User Manual Grandstream Networks, Inc.
17
6 Configuration Guide
6.1 Configuring HandyTone-486 through Voice Prompt
6.1.1 DHCP Mode
Follow section 5.1 with voice menu option 01 to enable HandyTone-486 to use DHCP.
6.1.2 STATIC IP Mode
Follow section 5.1 with voice menu option 01 to enable HandyTone-486 to use STATIC IP mode, then
use option 02, 03, 04, 05 to set up IP address, Subnet Mask, Gateway, and DNS server respectively.
6.1.3 Firmware Server IP Address
Follow section 5.1 with voice menu option 13 to configure the IP address of the firmware server.
6.1.4 Configuration Server IP Address
Follow section 5.1 with voice menu option 14 to configure the IP address of the configuration server.
6.1.5 Upgrade Protocol
Follow section 5.1 with voice menu option 15 to choose firmware and configuration upgrade protocol.
User can choose between TFTP and HTTP.
6.1.6 Firmware Upgrade Mode
Follow section 5.1 with voice menu option 17 to choose firmware upgrade mode among the following
three options:
- always check
- check when pre/suffix changes
- never upgrade
6.1.7 WAN Port Web Access
Follow section 5.1 with voice menu option 12 to enable WAN Port Wed Access of the device
configuration pages.
VoIPon www.voipon.co.uk [email protected] Tel: +44 (0)1245 808195 Fax: +44 (0)1245 600030