Heath Zenith Wireless Chime 598-1172-04 - Manual

TYPE
“D”
TYPE
“D”
TR-0035-R
X
© 2008 HeathCo LLC 598-1172-04
This package includes (Style of push button and chime may vary from illustration):
• Wireless chime cover
• Wireless chime base
• Wireless push button with battery • Hardware pack
This chime requires 3 “D” alkaline batteries (not included). In typical use, alkaline batteries
will last up to three years.
Wireless Chime
Battery Cover
1. Install alkaline type A23 12 volt push button battery
(included). Remove back of case by pushing in tab on bot-
tom with a small screwdriver (see Figure 1). See diagram
inside push button for correct battery orientation. Note: If
batteries are preinstalled, remove orange battery tab.
2. Remove chime cover. See page 2 to determine cover
mounting type.
3. Install 3 alkaline “D” batteries. Press down on imprinted
arrows and slide battery cover to remove (see Figure 3).
Make sure batteries are oriented properly (see Figure 4).
4. Test range. Temporarily position chime and push button
where you want them mounted. Press push button to verify
chime and push button work properly. If chime does not
sound, see Troubleshooting.
Mounting
Holes
TYPE “D”
TYPE “D”
TYPE “D”
1
2
3
4
5
6
7
8
VOLUME
WARNING: To prevent possible SERIOUS INJURY
or DEATH:
• NEVER allow small children near batteries.
• If battery is swallowed, immediately notify doctor.
Figure 1
Figure 2
Figure 3 Figure 4
Chime Volume